What Is Walk-In Shower Installation & Remodeling?
A walk-in shower removes the tub edge or high curb, replacing it with a low or curbless entry that's easier and safer to step into. In Albany, GA, this is one of the most requested upgrades since it modernizes the bathroom and improves accessibility for aging residents or anyone with mobility concerns. Installation reworks the shower pan, drainage slope, and waterproofing membrane — a curbless design depends entirely on precise slope work to keep water contained, making it a more technical build than a standard shower.
Why You Need It
Traditional tub-shower combos and high-curb stalls become genuine hazards over time — wet surfaces and a raised step create a real fall risk, especially for older adults or anyone recovering from an injury. An aging stall with degraded grout or a failing pan liner is also a common source of hidden leaks that can damage subfloor and framing before any staining shows up. Upgrading to a walk-in shower solves both problems at once, removing the physical hazard while replacing aging waterproofing with a modern system.
Our Process
Layout and Drain Planning
We determine the ideal drain location and slope pattern, since proper drainage is what makes a curbless design work.
Demolition and Waterproofing
The old tub or stall is removed and a full waterproof membrane is installed across the pan, walls, and curb area before tile.
Pan Forming and Tile Installation
The pan is sloped and formed to direct water precisely to the drain, then tile is set with attention to consistent slope lines.
Glass, Fixtures, and Final Seal
Glass panels or doors, showerheads, and controls are installed, and every seam is sealed for a watertight enclosure.
What to Expect
Installing a walk-in shower in Albany, GA typically takes one to two weeks, with most time spent on waterproofing and tile rather than demolition. Since slope and drainage are the most critical part of the build, we take extra care during pan-forming even if it adds a day or two. Once tile and glass are in, we run a full water test to confirm water flows correctly to the drain with no pooling.
Why Choose Harmony Kitchen Remodeling
Waterproofing is never rushed.
A curbless shower only works if the membrane and slope are done right, so we never shortcut this stage.
Accessibility-focused layouts.
We design entry width and bench placement with real mobility needs in mind, not just current trends.
Precise drain and slope work.
Getting the pan slope right prevents standing water, and it's where we spend the most careful attention.
Glass and fixture options for Albany, GA homes.
We help you choose glass configurations and fixtures that fit your bathroom's actual dimensions and your daily routine.
Frequently Asked Questions
A walk-in shower typically has a low or no curb, relying on precise floor slope and drain placement to keep water contained, making entry easier and safer.
Not if the slope and waterproofing membrane are installed correctly. The pan directs water to the drain, and the membrane keeps moisture from reaching the subfloor.
Yes, this is one of our most common projects. We remove the tub, rework plumbing and drain location as needed, and build a new sloped pan.
Comfortable walk-in showers generally start around 36 by 36 inches, though larger footprints allow benches or wider entries. We assess your bathroom during consultation.
Yes, built-in benches, fold-down seats, and reinforced grab bar placement can all be added during installation.
Once tile grout and sealant fully cure, typically 24 to 48 hours after installation, the shower is ready for regular use.